Assessment of Wheat Harvesting Losses with Different Combines and Provide the Necessary Solutions in Ardabil Province

Document Type : Research Paper

Authors

1 Academic Member, Department of Agricultural Engineering Research, Ardabil Agricultural and Natural Resources Research and Education Center, AREEO, Ardabil, Iran

2 Academic Member, Department of Agricultural Engineering Research, AREEO, Karaj, Iran

Abstract

Abstract
Harvesting is one of the most difficult and important stages of crop production. In this regard, 49 combine harvesters including conventional combines JD 955, JD 1055, CLASS-S 68 and NEW Holland TC 5080 were investigated in wheat farms in 5 cities of Ardabil provinces, during 2018. The measured parameters were preharvesting yield losses  and the losses at different sections of combine harvester such as cutting unit, threshing and separation unit, and storage tank, and also MOG percentage. The results showed that there was a significant difference between the harvesters in terms of losses and field capacity at the level of 1%. The highest effective field capacity was for NEW Holland TC 5080 combine with 1.16 ha hr-1 where the lowest losses with 0.99 percent belonged to the same. Head grain losses in John Dear, CLASS-S 68 and NEW Holland TC 5080 combines were about 68.5, 65.2 and 90 percent, respectively. Cutting platform losses in John Dear, CLASS-S 68 Combine and NEW Holland TC 5080 were 1.41, 1.64 and 0.99 percent, respectively. Processing losses in John Dear and Class combines were 0.67% and 0.87%, respectively, where it was only 0.04% for New Holland 5080 TC. The highest total losses were 2.51 percent obtained for CLASS-S 68 combine with 0.78 ha hr-1 field capacity. Useful quality losses were 0.52, 1.03, and 1.14%, respectively, for New Holland 5080 TC, John Dear and Class combines, respectively. In overall, the natural preharvesting losses rate was 3.74% and the average total losses for all combine harvesters was 1.94%. According to the results, in general it is recommended to use JD955 and TC5080 combine harvesters due to their low losses, acceptable wheat grain purity percentage and suitable field capacity.
 

Keywords


Amirnezhad, H., Rfiei, H., and Ataei, K. (2009). Investigating the effect of combine renovation on reducing wheat losses in the country. Journal of Agriculture, University of Tehran, Vol. 11(1): 1-20. (In Persian).
Anonymous. (2015). Agricultural Statistics Center forInformation and Communication Assistance of Technology.Planning and Economic, Ministry of Agriculture, Tehran, Iran.
Behroozi-Lar, M. (2000). Principles of Design of Agricultural Machinery. Scientific Publish Center of Islamic Azad University. Tehran, Iran. (In Persian).
Dehghan, E. (2008). Assessment of the amount and Reasons for losses products in combine for harvesting wheat in Khuzestan province.Final report of the research project. Khuzestan Agricultural and Natural Resources Research and
Education Center Registration number 88/947. (In Persian). 
Dehghan, A., Ivani, A., Hedayatipour, A., Asadi Khashvi, A., Taghinejad, J., Chaji, H., Sadeghnejad, H. R., Omidmehr, Z., Zarif Neshat, S., Abbasi, S., Afzali, S.M.J., Vahedi, A., Mehdi Nia, A., Gerami, K., Shaker, M., Saeedi Rad M. .,.,, Mostofi Sarkari, M.R., Rostami, M.A., Safari, M., Zabulistani M., and Sharif nasab, H. (2018). Measurement of combine losses of wheat grain harvest in the country in order to provide solutions to reduce it. Final report of Technical and Engineering Research Institute. Registration number 39565. (In Persian). 
Dehghan, E., Afzali, M., Alizadeh, M., Salehi,E., and Dibachi, E. (2009). Investigating the rate and causes of seed loss in wheat harvesting combines in Khuzestan province. Agricultural Engineering Research Institute (AERI). Final Report No.947/88. Karaj, Iran. (In Persian).
Khosravani, A., and Rahimi, H. (2005). Investigation of wheat harvest losses with combine harvester in Fars province. Journal of Agricultural Engineering Research. Vol 6 (25): 113-130. (In Persian).
Mostofi Sarkari, R., Mohammadi Asadi, N., Baghani, J., and Ghaffari, A. (2016). Effects of reducing and controlling losses of irrigated wheat combine harvesters in reducing water loss. Analytical Report. Registration number 51255. (In Persian). 
Mostofi-Sarkari, M.R., Nasehi, B., Saei, J., Farahmand, S., Raufi, M., Ghomashi, M., and Valaei, A. (2006). Measurement of grain combine loss in irrigated and rain fed wheat cultivation in seven provinces of the country in the crop year of 2004-2005. Ministry of Jihad Agriculture., Agricultural Engineering Research Institute. (In Persian).
Randal K. T., Hobby, H. M., and Schrock, M. D. (2005). Evaluation of an Automatic Feedrate Control System for a Grain Combine. ASAE Annual International Meeting. Paper Number: 051134.
Rostami, S., Lotfalian, M., and Hosseinzadeh Samani, B. (2018). Assessment and Comparison of Conventional and Straw Walker Combines Harvesting Losses in Fars Province.Agricultural Mechanization and Systems Research Vol. 19 (70): 85-96. (In Persian).
 Schueller, J. K. (1989). Digital simulation of combine reel and forward speed controllers. Computers and Electronics in Agriculture. Vol. 4 (1): 59-71.
Verma, R. B., Yadav, S. K., and Singh, A. K. (2000). Effect of wheat varieties on combine losses. Dissertation report, B. Tech. Department of Farm Machinery.